In this pic you'll see where this thin red wire was cut from the camera body and that I have no length of red wire to do a simple solder connection job: do take care and be very patient disassembling, cutting, soldering etc. This red wire seems to (may?) provide power to the pinhole camera and therefore there's no video signal to the RNS510 but the camera actually does pop out (guessing the yellow or brown wire provide power to eject the camera out still while in reverse). Guess the popping in and out of the camera and the cold weather during winter made this thin wire brittle and break and even worse it broke right at entry into the camera making the repair harder since I didn't have any red wire that I could simply solder to the cut end. The thin red wire that leads into camera body was cut. All of a sudden my rvc stopped working and would just give me the same black screen when in reverse (my camera would pop out but no video signal would be sent to my RNS510). I don't want to send it back well I don't want to remove it really. I'm out of options! Not sure if the kits not compatible but seller has assured me it is or coding is wrong. I've replaced the RGB box and harness for a new one. I then used a sony camcorder to feed video to the RGB box that's plugged to the RNS315, I didn't get any display other then the black screen when in R. The camera turns on when in R and the image was displayed on the computer monitor. I've tested the RVC by bypassing the RGB box and plugging the yellow RCA into a computer monitor. I had shop switch back to no camera installed and then once again to RVC installed via vagcom I've gone over all my connections and they are secure. Back in P the camera goes in and screen returns to normal. When in R the camera comes out, the RNS screen goes to black with the message to look! safe to move? but no video. Paid someone to enable Rear View Camera via VAG-COM
0 Comments
Leave a Reply. |